Replace Your Toilet Fill Valve in 12 Simple Steps

Turn off the water supply

To turn off the water supply to the toilet, rotate the shutoff valve clockwise. This valve is typically found on the wall behind the toilet or on the floor.

Empty the water in the tank

Hold the toilet handle down to empty out the toilet tank.

Disconnect the supply line

Hold a small bucket to catch water as it leaks out from disconnecting the toilet tank supply line.

Remove the fill valve lock nut

Remove the lock nut from the shank of the fill valve right above where you disconnected the water supply line on the outside of the toilet tank.

Disconnect the refill tube

Remove the toilet tank cover and set it aside somewhere it won’t interfere with your work. Detach the refill tube from the flow restrictor nipple inside the toilet tank, then remove the old fill valve from the toilet.

Install the flow restrictor

For some models of fill valve (including this one), there are a handful of flow restrictors that come with it in several colors: black, brown, clear, gray, blue, etc. Each colored restrictor restricts a different percentage of water flow to control the toilet bowl’s refill rate. Be sure to match the color of the flow restrictor on the old valve with the new one and install it.

Clean the fill valve location

If the location where the old valve was installed looks grimy or dirty inside the toilet tank, give it a quick wipe down with an old sponge or scrub brush.

Adjust the height of the new fill valve

This fill valve is adjustable in height, so you should rotate the new fill valve’s shank to match the old one’s length. A lock ring may need to be turned to allow the shank body to rotate, and then it should be turned again to lock it in place.

Secure new fill valve into tank

Insert the new fill valve into the toilet tank and secure it by hand-tightening the lock nut on the outside of the tank. Ensure that the rubber shank washer at the bottom of the fill valve seats well with the inside of the toilet tank.

Attach the refill tube to the fill valve

Connect the refill tube to the colored flow restrictor on the new fill valve.

Test the position of the fill valve

Ensure the fill valve is installed so the valve float can move freely up and down without obstruction. Test this by lifting up on the arm and seeing if the float hits anything. If there is interference, you may need to rotate the fill valve slightly.

Reconnect the water and flush

Tighten the water supply hose onto the fill valve shank and turn the water shutoff valve counterclockwise to turn the water back on. Then, flush the toilet.

If the float is stopping your toilet from completely filling or overfilling the toilet and letting it continue to run water down the overflow pipe, adjust the water level adjusting screw until the float engages at the water level mark labeled on the inside of the toilet or one to two inches below the top of the overflow tube.

Once you run a test flush to ensure that the toilet fill valve is working properly, you can put the toilet tank cover back into position.

FAQ

How often do toilet fill valves need to be replaced?

You should replace your toilet’s fill valve every four to five years.

How much slack should be in the toilet chain?

There should be about 1/2-in. of slack.

Can you replace a toilet fill valve without turning off the water?

No, you should turn off the water before replacing a toilet fill valve. To do this, rotate the shutoff valve clockwise. This valve is usually located on the wall behind the toilet or on the floor.